One shovel has many lengths. Collapse to 15-1/2", Extends to 21-1/2", 24" or 32". Handle snaps into Polaris Powder Keg or Fuel Keg

Fits cutout in the 2-3/4 gallon Ski-doo Fuel Keg (#XP-137-F) Carry extra oil or your favorite beverage. Shipping and handling on this item is free when you purchase over $100 of other products.

(2) - K-1 Keepers for mounting to the tunnel of certain snowmobiles. Original keeper needed for mounting all Ski-doo products and Arctic Cat products on 2011 and older model sleds. Each set comes with 2 Keepers and 6 stainless steel rivets.

(2) - K-2 Keepers for mounting to the tunnel of certain Polaris snowmobiles. This Keeper mounts by removing two nuts on the tunnel of most longer tracked Polaris snowmobiles. Each set comes with 2 Keepers.

(2) - K-3 Keepers for mounting to the tunnel of Polaris 155" or longer snowmobiles This is the Keeper that mounts in the rear position when mounting the P-300-B or P-200-F. Designed with a larger offset to fit over the rail on the side of the tunnel. Each set comes with 2 Keepers and 6 stainless steel rivets.

(4) - K-4 Keepers for mounting to the tunnel of the 2012 Arctic Cat snowmobiles. Each set comes with 4 Keepers and 16 stainless steel rivets.

DL-1 is the draw latch used on all storage boxes. This is a single draw latch. Latch Screws (LS-1) and Hex Pins (H-Pin) are NOT included.

DLF-2 is the draw latch used on the XP-146-F, P-200-F & AC-200-F. This is a single draw latch. Latch Screws (LS-1) and Hex Pins (H-Pin) are NOT included.

DLF-3 is the draw latch used on the XP-137-F & XP-120-F. This is a single draw latch. Latch Screws (LS-1) and Hex Pins (H-Pin) are NOT included.

GS-1 is the best spill resistant gas spout available. This is the same spout that ships with all Fuel Kegs. Fits several models of plastic fuel cans on the market.

GC-1 is the direct replacement gas cap on all Fuel Kegs.

This is the lid latch assembly that mounts on all of the Powder Keg storage boxes.

This is the 1" texture tape used to mount to the tunnel of Arctic Cat and Polaris snowmobiles. It offers a better surface on the tunnel for mounting the Powder Keg.

This is the 2" texture tape used to mount to the tunnel of Ski-doo snowmobiles. It offers a better surface on the tunnel for mounting the Powder Keg.

The H-Pin is the hex shaped pin that goes through the hole in all Powder Keg draw latches.

The LS-1 screw is used to mount the draw latches to the Powder Keg.

Felt Pads are for placing under the areas where the shovel blade of the AV-BLK will contact the tunnel of your snowmobile. These will reduce the blade scratching your tunnel.